View Single Post
Old April 4, 2012, 06:37 AM   #1
Junior Member
Join Date: September 24, 2011
Posts: 9
Can a bolt face be rebuilt?


i have a m17 rechambered for .243. The face of the bolt has some pitting around the firing pin hole. The primer of a fired case expands into the pitting and then the extra length makes it difficult to insert in the reloading press.

So My question is, can the bolt face be built back up and machined to the right spec's or do I put up with it?

2_Grumpy is offline  
Page generated in 0.03263 seconds with 7 queries