View Single Post
Old March 31, 2012, 12:47 PM   #3
howlnmad
Senior Member
 
Join Date: April 29, 2009
Location: Harriman Tn
Posts: 413
Resizing dies will actually size the brass to a smaller diameter than what new rounds will be. At times this will cause that bullet base line or coke bottle appearance, it is normal. The other possibilities are the setting of your die in relation to seating/crimping or the bullet not seating square or straight. You can try seating and crimping in different stages and see if that helps.
howlnmad is offline  
 
Page generated in 0.04159 seconds with 7 queries