View Single Post
Old March 25, 2012, 08:36 PM   #10
Sport45
Senior Member
 
Join Date: May 25, 1999
Location: Too close to Houston
Posts: 4,085
As Korny351 said, it depends on whether or not you got carried away when you adjusted the crimping die "a little tighter".

Go ahead and seat one to the proper length and then pull the bullet. If it looks like the case mouth dug in as it was seated deeper you should pull all of them and start over by resizing with the depriming pin removed. If the bullet looks okay reseat all of them and have fun shooting.

Use the barrel to test your cartridges for chambering. Don't try to use it for setting max cartridge length.
__________________
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Sport45 is offline  
 
Page generated in 0.04511 seconds with 7 queries