Thread: Pillar Bedding
View Single Post
Old March 23, 2012, 12:49 PM   #12
davem
Senior Member
 
Join Date: October 4, 2004
Posts: 330
Well I guess I'm not getting my question answered- on the net there are some sites that show how to pillar bed and that looks like that is the end of the job- there is a little glass bedding around the pillars. The type of glass bedding I'm familiar with usually includes the whole action area of the stock.
Should I first put in the pillars and let them set and THEN remove any high wood from the other areas of the action area and then glass bed those areas? It would seem first putting in the pillars is logical because then you could screw the barrel down on the plliars and the rest of the action area would then conform to the bedding job. In other words- how do you go about it. OR..... is the pillars enough and you should forget about bedding any other area of the stock?
Thanks again for any help.
davem is offline  
 
Page generated in 0.04159 seconds with 7 queries