View Single Post
Old March 20, 2012, 02:07 PM   #4
Northern Gal
Member
 
Join Date: April 5, 2011
Posts: 29
CowTowner: The problem I'm having is that the right edge will not fit to slide down under the notch in the slide - it hits that piece on the right that butts up to it when it's in place correctly. I'm obviously doing something wrong such that the hole that lines up w/ the barrel for the slide stop to go into is just a bit too far right. (Does that make sense?)
Northern Gal is offline  
 
Page generated in 0.05685 seconds with 7 queries