View Single Post
Old March 15, 2012, 12:59 PM   #11
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 10,277
And it's probably not Lake City brass, per se (good stuff), but what fired it last that's the issue. Lot's of it is once-fired machine gun feed, and the rims are often bent back by that experience, but not all over. Set them up on a table and see if any of them lean to the side. If not, it's probably still just a matter of them having been too long at one point and springing back a lot coming out of the sizing die.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member

Last edited by Unclenick; March 15, 2012 at 01:06 PM.
Unclenick is offline  
 
Page generated in 0.04284 seconds with 7 queries