View Single Post
Old March 13, 2012, 10:02 PM   #13
GAR700
Senior Member
 
Join Date: September 22, 2008
Location: East of the Crest, Oregon
Posts: 178
So I besically narrowed it down to something being wrong with the way my upper is alligned. I tried the upper on two other good lowers and it would not function. I tried my lower on two other uppers and it worked just fine. So I may try and find a stripped upper and have it swapped into the assembly I have. Thanks for the input.
GAR
GAR700 is offline  
 
Page generated in 0.07032 seconds with 8 queries