View Single Post
Old March 13, 2012, 04:32 PM   #1
Twycross
Senior Member
 
Join Date: January 26, 2005
Location: Montana
Posts: 1,187
Problem with chambering

I reload 7mm WSM, and the last batch had an issue I cannot figure out. All the rounds I did that day were stiff to chamber, difficult to extract, and several showed signs of overpressure.

I've never had this issue with factory ammunition, or with anything else I've reloaded. I've checked the unfired loads from this batch, and they are dimensionally identical to the round I reloaded just now (which chambers fine), and well within specs. Anybody know what might have caused this?
__________________
The test of character is not 'hanging in' when you expect light at the end of the tunnel, but performance of duty, and persistence of example when you know no light is coming.
- Vice Admiral James Stockdale, USN (ret.)
Twycross is offline  
 
Page generated in 0.07874 seconds with 7 queries