View Single Post
Old February 26, 2012, 09:49 AM   #8
Arub
Senior Member
 
Join Date: January 20, 2001
Location: UCLA (upper corner of lower Alabama)
Posts: 512
I measure the OAL of both bullets and adjust cartridge OAL of the new to match the case mouth to bullet base measurement/calculation of the old. Also, to someone else'a point, I make up a dummy round to check seating in the chamber before loading hundreds of rounds. Wasn't smart enough to do that twice (slow learner).
Arub is offline  
 
Page generated in 0.04581 seconds with 7 queries