View Single Post
Old February 23, 2012, 04:31 PM   #10
K1500
Senior Member
 
Join Date: December 24, 2011
Posts: 158
These are all just WAG's on my part. I would try kroil or PB Blaster first. then I would try a soldering iron on the head of the screw. Be sure to clean off all the Kroil before using heat. Make sure the driver fits perfect before you turn the screw. Also, you might be able to break it free by attempting to tighten it a bit if it will not come out. One more thing might be to peck on the end of the driver with a hammer to vibrate it a bit.
K1500 is offline  
 
Page generated in 0.04307 seconds with 7 queries