Thread: Naked Slide
View Single Post
Old February 16, 2012, 01:50 PM   #5
Arbuk
Junior Member
 
Join Date: February 14, 2012
Posts: 7
Quote:
Lurch37
Interesting...perhaps another option would be to mill off the offending lettering on the slides as long as the lettering isn't to deep.
That could work. I thought of putting it on the surface grinder
but didn't want to remove the square cut serrations on the
rear of the slide. I suppose I could take a slight "high power"
cut back to the first slide serration. The lettering isn't as deep
as the serrations.

Last edited by Arbuk; February 16, 2012 at 01:58 PM.
Arbuk is offline  
 
Page generated in 0.04151 seconds with 7 queries