View Single Post
Old February 7, 2012, 05:51 AM   #10
hardworker
Senior Member
 
Join Date: August 4, 2010
Posts: 820
The gas seal is part of the cocking check. If the gun fully cocks, the cylinder will mate up with the forcing cone. The cylinder is milled out for the forcing cone, it either fits or it doesn't. As far as serial numbers, the mainspring had one on it, but it looked like it was put there by some guy in a cave with a rock. I think the inside of the grip frame had one, I can't remember. I got rid of mine because it didn't work right. Thing would decock instead of shoot when I pulled the trigger.
hardworker is offline  
 
Page generated in 0.05056 seconds with 7 queries