View Single Post
Old February 2, 2012, 06:50 PM   #10
Pagrizz
Junior Member
 
Join Date: December 28, 2011
Location: PA/Maine
Posts: 7
I sent the rest of the box back to the factory.I always check the barrel before I put the first round in.Was it that round or was that the last one it could handle.I probably will never know.I know that that action should be able to take the 300 and over the last few days have been told by many the samething.I keep a book on all my guns. On loads, how they shot that day,any problems closing or opening the bolt .When sizing the brass I always use a full length die .Trim them as soon as they need it.Never went near a max load with that gun.I followed the same routine I have been doing for 48 years of shooting.All I know is I lost a very good gun and do not know why

Last edited by Pagrizz; February 3, 2012 at 10:18 AM.
Pagrizz is offline  
 
Page generated in 0.04278 seconds with 7 queries