View Single Post
Old February 1, 2012, 11:33 AM   #5
crispy
Member
 
Join Date: August 14, 2011
Posts: 66
BTW, I this wasn't my first problem. I ordered a set for a Bersa Thunder 380CC.

Those fit fine but the left and right sides were not cut from the same stock. Since they were covered in clear shellac (no stain) it was very noticeable. I don't understand whey he would even ship them.





No response on an e-mail I sent then too. But alas, I still ordered the set for the P232 above. I figured the Bersa grips fit fine and since I was ordering a stained set, they'd have to match...

Last edited by crispy; February 2, 2012 at 08:25 AM.
crispy is offline  
 
Page generated in 0.04877 seconds with 7 queries