Thread: Greetings...
View Single Post
Old January 31, 2012, 02:42 AM   #13
barakmd
Junior Member
 
Join Date: January 27, 2012
Location: WA State
Posts: 9
So I picked up some feeler gauges to check the forcing cone/cylinder gap on my Centaure 1860 and here are the results;

Half cock-20mm (corrected .020)
Full cock-12mm (corrected .012)

Are these acceptable results or should I be concerned?

Last edited by barakmd; February 1, 2012 at 12:08 AM.
barakmd is offline  
 
Page generated in 0.04206 seconds with 7 queries