Thread: shell holders
View Single Post
Old January 29, 2012, 08:16 PM   #10
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 2,515
“allowing the case to go up farther into the die?” back to deck height, the deck height of both shell holders is .125, that means the deck of the shell holder is .125 from the bottom of the die, when the clearance between the die and shell holder is .000 with the ram up the press is in full length sizing/minimum length mode. Then there are the + and or – factors.

F. Guffey
F. Guffey is offline  
 
Page generated in 0.04134 seconds with 7 queries