View Single Post
Old January 29, 2012, 11:14 AM   #6
mdevlin53
Member
 
Join Date: January 7, 2012
Location: new york
Posts: 21
getting to the bare wood

I just spent another hour sanding this stock. The paper is still getting gummed up so that means i am still removing finish and stain or so i beleive. The fellow who did the original sporterization must have used 80 grit and a file because there are a lot of deep sanding scratches in the wood. It is looking better but in the end the wood is nothing special. I understand that these guns were mass produced and were not meant to be pretty so if i can get it to look uniform without any real dark spots i will be happy. The stain. its not like i have another peice of wood to test it out on,
mdevlin53 is offline  
 
Page generated in 0.04312 seconds with 7 queries