View Single Post
Old January 29, 2012, 02:18 AM   #6
Sport45
Senior Member
 
Join Date: May 25, 1999
Location: Too close to Houston
Posts: 4,050
Quote:
Originally Posted by 0302Grendel
Issues – when seating the bullets in the PPU brass, there was a WIDE variation of seating depths – OAL from 2.70 to 2.55.
That's a quarter-inch of variance. Are you sure you're getting all the zero's in there or the decimal in the right place?

The seating die should put you pretty close to the same overall length no matter what brass is used. The only variance should be in individual bullet geometry.
__________________
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Sport45 is offline  
 
Page generated in 0.05034 seconds with 7 queries