View Single Post
Old January 26, 2012, 02:27 PM   #24
halfslow
Junior Member
 
Join Date: January 25, 2012
Posts: 6
That looks like a great way to sneak up on the proper gap and leave a smooth finish.
Right now, the gap is 6 thou on the left and 4 on the right, and kinda crooked from top to bottom.
I figure the mill, using about 2 thou passes, will straighten it out.
Then I can use the wet-or-dry to leave a surface that will be easy to clean.
halfslow is offline  
 
Page generated in 0.04639 seconds with 7 queries