View Single Post
Old January 22, 2012, 04:18 PM   #9
Senior Member
Join Date: January 7, 2012
Location: Auburn, AL.
Posts: 1,834
Okay, got it apart and have tools handy. Now, the questions. Here is the bolt as she exists.
Here's a closer view.
And I didn't realize it was gonna be this small.
So, the plan is to smooth down (blend in) the bevel on the leg to the right in this pic?
and even closer. . .
I think smoothing the bevel will be easy. But just how to narrow only the little blackened area of the bolt from will be quite a challenge. Here's where I could use suggestions on technique.
Beagle333 is offline  
Page generated in 0.06533 seconds with 7 queries