View Single Post
Old January 15, 2012, 07:15 PM   #10
tobnpr
Senior Member
 
Join Date: August 1, 2010
Location: Tampa Bay
Posts: 2,887
Just in case you weren't aware, when setting the action screws place the rifle butt down, and give it decent "bump" down onto the floor before tightening the front action screw first. This makes sure the recoil lug is firmly seated to the rear. Then tighten the rear action screw. Might help your alignment (and accuracy) if you're not doing this, dunno...
tobnpr is offline  
 
Page generated in 0.04643 seconds with 7 queries