View Single Post
Old January 14, 2012, 10:10 AM   #12
Doc Hoy
Senior Member
 
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 4,562
This is what I did....

....in a similar situation...






BUT!

In order to get the union of the two parts to look right it takes either careful work by hand or it takes a milling machine.

AND!

As others have said, this may throw off the arbor length and the location of the slot.

I think that barrel did not come with that frame or perhaps that cylinder did not come with that frame and barrel.
__________________
Doc

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
 
Page generated in 0.04447 seconds with 7 queries