The Firing Line Forums - View Single Post - Correcting the gap between cylinder and forcing cone on '51?

illus1on · January 14, 2012, 08:52 AM

Hi guys.

i did what you asked and it is too far back (going past where it is supposed to)

what confuses me tho is if its already going too far back and if i add material to correct this wouldnt that make the gap even bigger?

ill try and obtain a caliper or some feelers to measure the gap.

and this is a steel frame.

January 14, 2012, 08:52 AM	#10
illus1on Member Join Date: December 26, 2011 Location: BC, Canada Posts: 37	Hi guys. i did what you asked and it is too far back (going past where it is supposed to) what confuses me tho is if its already going too far back and if i add material to correct this wouldnt that make the gap even bigger? ill try and obtain a caliper or some feelers to measure the gap. and this is a steel frame. __________________ "God made man... But sam colt made em equal."