View Single Post
Old December 22, 2011, 10:30 PM   #1
Don P
Senior Member
Join Date: December 17, 2005
Location: Florida
Posts: 4,893
Chamfering a Revolver Cylinder

For any of our distinguished gun smiths. Does chamfering the cylinder to aid in reloading have any ill effect on the performance or allow any gases to possibly blow back due to the chamfering?. Possible cost if anyone is does this. Gun is a Ruger GP-100
NRA Life Member, NRA Range Safety Officer, IDPA Safety Officer, USPSA NROI Range Officer
As you are, I once was, As I am, You will be.
Don P is offline  
Page generated in 0.04404 seconds with 7 queries