View Single Post
Old December 20, 2011, 05:53 PM   #21
orionengnr
Senior Member
 
Join Date: July 9, 2004
Posts: 4,964
Did you ever determine the correct dimension, and see where your part sits?

If I read it correctly, you on your third FP and at least your second spring. Parts/spring changing and modifying parts, etc...a lot of misguided effort, IMHO...until you know which part is actually out of spec, you are Band-Aiding the problem.
orionengnr is offline  
 
Page generated in 0.04754 seconds with 7 queries