Triple 7 loads for .50 cal Round Ball
I have been trying to find a recommended loads for Triple 7. I have a CVA sidelock percussion with a 1/48 twist. It is a Plainsman I built from a kit. I have only had it out to the range 3 times, I bought it 10 years ago and put it together 5 years ago. I started low to sight it in. It groups well on the mid range at 25 yards but shoots about 6 inches low. I am using 55 grains for triple 7 and a speer .490 round ball over a pre-lubed patch. At this point should I look to increase the charge or change the sights. The rear sight is fixed buckhorn.
From the People's Republic of Massachusetts