View Single Post
Old December 18, 2011, 11:21 AM   #6
bobco
Junior Member
 
Join Date: December 17, 2011
Posts: 4
Need help on putting the bolt back together

The firing pin and the extractor are back in, hopefully correctly, and now I need to put the cocking pull back in the bolt. What is the proper way of putting the pin back in when it looks like the pin has to pass through the spring? How do I get the spring out of the way? Is the spring supposed to be compressed? When I took it apart it didn't seem to be under any pressure.

Should I post this in the smithy forum?

Thanks

Last edited by bobco; December 18, 2011 at 11:23 AM. Reason: more info
bobco is offline  
 
Page generated in 0.07846 seconds with 7 queries