View Single Post
Old December 15, 2011, 09:02 AM   #4
Rifleman1776
Senior Member
 
Join Date: April 25, 2010
Location: Arkansas
Posts: 3,309
Don't smoke the moulds. Make sure the plates are clean. Also make sure the two halves are properly closed. I have done a considerable amount of casting with Lee moulds and have found them OK. Not great but servicable and OK.
The lining up of the two halves is my biggest problem, just take a second to make sure it is closed properly. And, you may not be using enough heat.
Rifleman1776 is offline  
 
Page generated in 0.05641 seconds with 7 queries