Thread: Rifle Id.
View Single Post
Old December 3, 2011, 01:00 PM   #9
jimbob86
Senior Member
 
Join Date: October 4, 2007
Location: All the way to NEBRASKA
Posts: 6,452
Quote:
Ok, just got back from the gunsmith and he couldnt confirm what round it was chambered for. He said since there arent any markings that he would have to take it apart to tell.
I don't think you have to disassemble the gun to slug the bore and try a few headspacing guages .... Either your gunsmith does not know his business, or was more likely blowing you off ....

Quote:
Im gonna go to another gunsmith and get his opinion.
Ask how much it would cost to make a chamber cast...... or DIY it. It is not hard. 1/2 lb of cerrosafe is $20-$25 bucks......

http://4-dproducts.com/submenu/Cerosafe.htm

http://www.brownells.com/.aspx/pid=3...-CASTING-ALLOY
__________________
TheGolden Rule of Tool Use: "If you don't know what you are doing, DON'T."

http://nefirearm.com/
jimbob86 is offline  
 
Page generated in 0.05026 seconds with 7 queries