Thread: Simple casting?
View Single Post
Old November 13, 2011, 03:32 PM   #9
Rangefinder
Senior Member
 
Join Date: August 4, 2005
Posts: 2,017
Quote:
If anyone has a sure fired way to check out 9mm without sizing, please let me know. I thought about taking my High Point C9 apart so I can access the chamber and test 'em that way. WRL
For inspecting bullets, it's not much to worry about. Visually glance--if lines are all crisp and your fill-out is uniform, then mic a couple to see what diameter they're dropping at. If that spec's ok, that's all you need to worry about. If it's chambering you're concerned with, do the same as you would anyway as a reloader--load a dummy, and chamber it. Pre-firing, that's about all the inspection you really need. Now, loading and development is another issue entirely.
__________________
"Why is is called Common Sense when it seems so few actually possess it?"

Guns only have two enemies: Rust and Politicians.
Rangefinder is offline  
 
Page generated in 0.04266 seconds with 7 queries