View Single Post
Old November 12, 2011, 02:36 PM   #9
hornetguy
Senior Member
 
Join Date: January 14, 2011
Location: on the north side of DFW
Posts: 801
Quote:
This is a good one for both punching holes in paper and loading quickly from a speed loader. The only thing that keep it from being a *great* bullet is the bevel base. I'm thinking about cutting the bevel out of my mold.
That's very easy to do, if you have access to a lathe with a 4-jaw chuck. I did it to a single cavity Lee mold for the .375 Winchester. It worked very well.

I suppose if you had a REALLY steady hand, you could do it with a Dremel. Better have de-caf the morning you try that, though..
hornetguy is offline  
 
Page generated in 0.04395 seconds with 7 queries