View Single Post
Old October 28, 2011, 11:06 PM   #6
James K
Staff
 
Join Date: March 17, 1999
Posts: 18,649
I don't have one of those now, but had some at one time and the firing pin should not be hard to make, just a matter of making it fit. I suggest taking a thick piece of cardboard and cutting it until it seems to fit, then switch to brass or aluminum, which are easy to work. Once you get something that works, you can go to steel using the brass or aluminum part as a model. Leave the firing pin part to the last so you can adjust the protrusion.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.05030 seconds with 7 queries