View Single Post
Old October 17, 2011, 03:49 PM   #10
brickeyee
Senior Member
 
Join Date: December 29, 2004
Posts: 3,342
Quote:
Yikes! $53 just for the neck sizing die?

It might not be much more to get a competition neck sizing die and have the sliding sleeve bored out with the same reamer used to chamber the barrel (unless Redding lists the die you want).

You will also need a shoulder bump die at some point.

Last edited by brickeyee; October 17, 2011 at 03:56 PM.
brickeyee is offline  
 
Page generated in 0.04102 seconds with 7 queries