View Single Post
Old February 6, 2001, 03:55 PM   #9
Reg
Member
 
Join Date: January 13, 2000
Posts: 54
After reading this thread, I'm surprised nobody has suggested this:
- is your decapping pin set low enough in the die?

On occasion, I have had a case with a non-centered flash hole that caused the decapping pin to be pushed up in the die a little. This started to cause primers that would 'hang' in the case and not get pushed all the way out.

Worth checking if you haven't already.
Reg is offline  
 
Page generated in 0.04929 seconds with 7 queries