View Single Post
Old October 11, 2011, 06:42 PM   #10
serf 'rett
Senior Member
 
Join Date: June 25, 2009
Location: Stuttgart
Posts: 1,316
I just remove the mouth expansion on my 40S&W and it's good to go.

Is the crimping pressure causing the case to expand or belly out below the bullet?

Since it's 40S&W, have you carefully checked that the brass does not have a "belly" found in brass fired in pistols which have unsupported areas on the ramp. There’s a reason die makers sale “de-Glocking” fixer dies.
__________________
A lack of planning on your part does not necessarily constitute an emergency on my part.
serf 'rett is offline  
 
Page generated in 0.04075 seconds with 7 queries