View Single Post
Old October 11, 2011, 03:18 AM   #2
Jimro
Senior Member
 
Join Date: October 18, 2006
Posts: 5,678
I don't know what model of revolver you have, but if the bullets won't go through the cylinder I would clean the heck out of the pistol. Also I would check to make sure your cast bullets are in fact .357 and if they are I would start load workup with them.

The cylinder might be tight to prevent "bullet creep" from a heavy recoil dislodging bullets.

Jimro
__________________
"Gorsh" said Goofy as secondary explosions racked the beaten zone, "Did I do that?"

http://randomthoughtsandguns.blogspot.com/
Jimro is offline  
 
Page generated in 0.04397 seconds with 7 queries