View Single Post
Old October 5, 2011, 02:26 PM   #11
Magnum Wheel Man
Senior Member
 
Join Date: July 26, 2006
Location: Southern Minnesota
Posts: 8,180
picked up the revolver today... it's in beautyful condition... ( though the cylinder pin is stuck ) the cylinder is stepped, I tried a 44 special cartridge, & it fits nicely ( or would ) if I trimmed off 1/4" off the case length... bullet was tight enough fit in the bore to get belly gun accuracy... now looking for a very light cast bullet or mold to load in the cartridge... should be interesting... the hole in the end of the barrel is impressive, since the gun is about the same size as a 3" barrel J frame
__________________
In life you either make dust or eat dust...
Magnum Wheel Man is online now  
 
Page generated in 0.04793 seconds with 7 queries