View Single Post
Old February 5, 2001, 07:01 PM   #8
linngl
Member
 
Join Date: December 1, 1999
Location: Sherman,Tx,USA
Posts: 40
I had one do this on a Pro 2000. I had set the decapping pin to just barely protrude below the bottom of the case. I just screwed the decapping assembly until it just touches the bottom of the case and back up a 1/2 turn no more problem. This allows the pin to extend down into the drop tube. This was only with a straight wall case (.357 mag Starline) so expander ball is not a problem.
linngl is offline  
 
Page generated in 0.03984 seconds with 7 queries