View Single Post
Old September 25, 2011, 09:09 PM   #6
Senior Member
Join Date: August 4, 2005
Posts: 2,017
Prewarming is key. I use a coleman camp stove during casting and prewarm right in the flame. Run your melt a little on the "cool" side and your mold HOT with plenty of the heat on the sprew plate. Lots of pretty boolits quick that way.
"Why is is called Common Sense when it seems so few actually possess it?"

Guns only have two enemies: Rust and Politicians.
Rangefinder is offline  
Page generated in 0.04343 seconds with 7 queries