View Single Post
Old September 20, 2011, 03:05 AM   #2
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
You should be able to use your dies. You will have to get a couple extra dies too. You put the full length sizer at station one which decaps also, then you will need a Dillon powder die, and a conversion kit for your xl650 which will include the shell holder plate and the correct powder die insert.

The seating die can be adjusted to only seat the bullet and not crimp it. You can easily install an after market crimp die of your choice for the last station on your 650 to crimp in a separate step or not at all.
Edward429451 is offline  
 
Page generated in 0.06178 seconds with 7 queries