View Single Post
Old September 17, 2011, 08:44 PM   #2
Doodlebugger45
Senior Member
 
Join Date: April 15, 2009
Location: Wyoming
Posts: 1,717
At the risk of sounding obvious, did you trim the cases first? If they are too long, they might chamber when unloaded since the mouths have a little bit of flex, but when you seat a bullet, they won't chamber well if they are a bit long.

It sounds like the overall length with a bullet isn't the problem since you went way short. And it sounds like you solved the sizing problem. That only leaves the trim length.
Doodlebugger45 is offline  
 
Page generated in 0.04640 seconds with 7 queries