View Single Post
Old September 16, 2011, 10:49 PM   #2
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 3,061
Can you post a pic?

Although the 700 appears to use a shrouded/push feed design, I can't visualize how the bolt extends much past the extractor groove.



Q1: Can you feel ANY burr on the inside of the shroud?
Q2: How about the edges of the ejector cutout in the shroud? smooth or sharp?
Q3: And does the base of the case show a round imprint/smear where brass might be flowing into the ejector slot(hole)?

Last edited by mehavey; September 16, 2011 at 10:56 PM.
mehavey is offline  
 
Page generated in 0.05238 seconds with 7 queries