View Single Post
Old September 15, 2011, 08:26 AM   #89
akumabito
Junior Member
 
Join Date: September 13, 2011
Posts: 13
Well that was easy enough.. again, the dimensions are bound to be incorrect, I'm just working off guestimates here.. I modified the push rod, it's now double the diameter of the original design. 4mm, that's about 1/6 of an inch - I don't think it'll bend when pushing the hammer back. I also added the O-rings here..

akumabito is offline  
 
Page generated in 0.04122 seconds with 7 queries