View Single Post
Old September 7, 2011, 12:27 PM   #1
Osage
Member
 
Join Date: September 27, 2005
Location: Missouri
Posts: 69
May start pouring my own 8mm

Bought a pair of steyrs that come with the dies and mold (8x56). I have a lee melting pot that I use with round ball but have never cast boolits. Been doing some reading so I now understand the lube and gas check issues. I was surprised by the low charges used. When using charges under 15 gr, is a fast powder required? I use mostly varget but never see that mentioned.
Other than casting the boolit, is the rest of the reloadimg process the same?
Osage is offline  
 
Page generated in 0.04149 seconds with 7 queries