View Single Post
Old August 20, 2011, 03:20 PM   #1
Char181
Junior Member
 
Join Date: August 16, 2011
Posts: 8
Stock modifications for sawed off shotgun

New to the forum and have done some searching on this topic but haven't found much help. I posted in the NFA Section with no reply's yet. Thought i would try here. I am in the research stage and will file my paperwork for the stamp soon. I will cut the barrels to about 13" and have an overall 21-1/2" length. I want to refinish the barrels and receiver to a quality finish and have a gun I am proud to show. The stock is my only concern. I want to cut the original pistol grip stock to leave only the pistol grip but don't know what to do with the hole that will be left in the grip where the bolt goes through that attaches stock to receiver. How have some of you handled this in a cosmetically pleasing manner? I may even have the grip re-checkered and nicely finished to complement the other re-finishing. Any suggestions, thoughts, links, or pictures would be appreciated.
Char181 is offline  
 
Page generated in 0.05258 seconds with 7 queries