Thread: Getting started
View Single Post
Old August 15, 2011, 02:48 PM   #35
GregInAtl
Senior Member
 
Join Date: December 29, 2010
Location: Gwinnett County Georgia
Posts: 788
Quote:
Originally Posted by praetorian97
Bolted. But you can bolt to a piece of wood/metal and clamp that to a table.
Just curious cause I was thinking of doing this. It seems that if you bolted the press to a piece of wood and then used clamps to clamp it to the table that the bolts would stick out the bottom side of the piece of wood and it woudn't lay level on the table.
__________________
Do not follow where the path may lead, go instead where there is no path and leave a trail - Ralph Waldo Emerson
GregInAtl is offline  
 
Page generated in 0.04221 seconds with 7 queries