View Single Post
Old August 15, 2011, 11:41 AM   #15
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,211
Many gun clubs have a "bore gague" ....that they will let you use at a table in the clubhouse - to check the diameter of the bore against the diameter of the various chokes --- and calculate that difference ...which is what you want to know. Most of us don't own bore gagues...

Ideally you should check every screw in choke you have - regardless of what they're marked / they could differ more than you would think.

Most every 12ga barrel will be a little different --- even within the same mfg's ...
BigJimP is offline  
 
Page generated in 0.04772 seconds with 7 queries