View Single Post
Old August 13, 2011, 12:51 AM   #4
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Thanks Zippy. I was trying to compare the muzzle end of the choke threaded into my 28 inch barrel with the muzzle end of a cyllinder bore 18 1/2" barrel. Probably the easiest thing for me to do is to go to the patterning board. I read it at a restriction of .012", which would be more like a skeet choke if not for the fact that I likely am not measuring deep enough into the bore.
TheKlawMan is offline  
 
Page generated in 0.04346 seconds with 7 queries