View Single Post
Old August 4, 2011, 09:07 PM   #2
jepp2
Senior Member
 
Join Date: December 24, 2008
Location: Loveland, CO
Posts: 1,326
No problem at all. It will increase the peak pressure slightly due to lower case capacity.

I am assuming that you are following proper practices and not starting at a max load. Realize that you could be using a different bullet than the load was developed with. Bullet lengths can vary between manufacturers for the same diameter and weight. So even if you loaded to the exact same COL, the seating depth could be different.
jepp2 is offline  
 
Page generated in 0.04823 seconds with 7 queries