View Single Post
Old July 27, 2011, 10:37 PM   #2
NESHOOTER
Senior Member
 
Join Date: October 16, 2009
Posts: 509
Quote:
Right now I lube, resize and deprime, tumble, trim, debur and then hand prime. I guess I am wondering what you guys do who use progressive press's with these steps?
You got it down ok, and I as well hand prime not so much because my progressive won't handle it but one less station to watch, but when I use extruded powder (varget,IMR,HODGEN). On my L-N-L any less crunching the better this way I feel only the powder and cycle them through without a hitch the smoother it puts them out.
NESHOOTER is offline  
 
Page generated in 0.04155 seconds with 7 queries